Ara
Toplam kayıt 102, listelenen: 91-100
Energy and exergy analyses in a rotary burner with pre-calcinations in cement production
(Pergamon-Elsevier Science Ltd, 2004)
Cement production facilities are often located in rural areas and close to quarries, where the raw materials required for cement production are present, i.e. limestone and shale. Although energy analysis, based on the first ...
A study for estimating solar resources in Turkey using artificial neural networks
(Taylor & Francis Inc, 2004)
Turkey has sufficient solar radiation and radiation period for solar thermal applications since it lies in a sunny belt between 36degrees and 42degreesN latitudes. The yearly average solar radiation is 3.6 kWh/m(2) day, ...
Performance prediction of a vapour-compression heat-pump
(Elsevier Sci Ltd, 2004)
The performance of the heat pump was predicted using a fuzzy-logic controller under various working-conditions and mixing ratios of R12/R22 refrigerant mixtures, instead of requiring an expensive and time consuming ...
A new approach to thermodynamic analysis of ejector-absorption cycle: artificial neural networks
(Pergamon-Elsevier Science Ltd, 2003)
Thermodynamic analysis of absorption thermal systems is too complex because of analytic functions calculating the thermodynamic properties of fluid couples involving the solution of complex differential equations. To ...
The effect of stacking sequence of carbon epoxy composite laminates on pinned-joint strength
(Elsevier Sci Ltd, 2003)
In this paper, an experimental study regarding the determination of the safe as well as the maximum bearing strengths of a pinned-joint carbon epoxy composite laminate with [0degrees/45degrees/-45degrees/90degrees]s and ...
An investigation of the effects of shear on the deflection of an orthotropic cantilever beam by them use of anisotropic elasticity theory
(Elsevier Sci Ltd, 2001)
Two deflection functions due to both flexure and shear of an orthotropic cantilever beam subjected to both point and distributed loads have been obtained by the use of anisotropic elasticity theory. The deflections at the ...
An investigation of rolling element vibrations caused by local defects
(Asme-Amer Soc Mechanical Eng, 2008)
In this paper, a shaft-bearing model is developed in order to investigate the rolling element vibrations for an angular contact ball bearing with and without defects. The shaft-bearing assembly is considered as a mass-spring ...
Artificial neural network application to the friction-stir welding of aluminum plates
(Elsevier Sci Ltd, 2007)
An artificial neural network (ANN) model was developed for the analysis and simulation of the correlation between the friction stir welding (FSW) parameters of aluminium (Al) plates and mechanical properties. The input ...
Design optimization of cutting parameters when turning hardened AISI 4140 steel (63 HRC) with Al2O3+TiCN mixed ceramic tool
(Elsevier Sci Ltd, 2007)
Due to their high hardness and wear resistance, Al2O3-based ceramics are one of the most suitable cutting tool materials for machining hardened steels. However, their high degree of brittleness usually leads to inconsistent ...
Designing of a powder compressing device with vibration and investigation of compressibility of MgO powders with this device
(Elsevier Sci Ltd, 2007)
One of metal matrix composite (MMC) production methods is infiltration of liquid metal into preformed reinforcement. In this method, MMCs are produced by infiltration of liquid metal into preformed reinforcement using one ...