Ara
Toplam kayıt 95, listelenen: 51-60
Effect of Infiltration Pressure on Thermal Conductivity of Al 2014 Matrix Composite Powered by Silicon Carbide
(Asian Journal Of Chemistry, 2012)
By using pressure infiltration method, metal matrix composites are produced by saturating Al 2014 aluminum composite to the gaps among SiC powders. SiC powders filled into stainless steel tubes are fastened between the ...
Clamp fixation to prevent unfolding of a suture knot decreases tensile strength of polypropylene sutures
(Springer, 2012)
Purpose Although sutures evolved in last decade and the product spectrum broadened largely, they can be still classified into two: monofilament and multifilament. Sutures are the mainstay of orthopedic procedures like ...
Experimental robust optimal machining of hardened AISI 420 stainless steel with Al2O3+TiCN mixed ceramic tool
(Sage Publications Ltd, 2011)
The high hardness and wear resistance levels of Alumina (Al2O3)-based ceramics make them excellent choices for incorporation into cutting tools that can be used to machine hardened steels. However, their poor fracture ...
Investigation of the design of a metal-lined fully wrapped composite vessel under high internal pressure
(Taylor & Francis Ltd, 2010)
In this study, a Type III composite pressure vessel (ISO 11439: 2000) loaded with high internal pressure is investigated in terms of the effect of the orientation of the element coordinate system while simulating the ...
Derivation of empirical equations for thermodynamic properties of a ozone safe refrigerant (R404a) using artificial neural network
(Pergamon-Elsevier Science Ltd, 2010)
This study, deals with the potential application of the artificial neural networks (ANNs) to represent PVTx (pressure-specific volume-temperature-vapor quality) data in the range of temperature of 173-498 K and pressure ...
Sliding Friction and Wear Behavior of Pack-Boronized AISI 1050, 4140, and 8620 Steels
(Taylor & Francis Inc, 2008)
This paper describes the dry sliding friction and wear performance of boronized AISI 1050, 4140, and 8620 steels with the Fe(2)B phase coating on the surface. The studies were carried out using a pin-on-disc arrangement. ...
Evaluation of flow behavior for clearance brush seals
(Asme-Amer Soc Mechanical Eng, 2008)
The industrial applications of brush seals have been increasing due to their superior sealing performance. Advances in the understanding of seal behavior have been pushing the design limits to higher-pressure load, ...
Sea water effect on pinned joint glass fibre composite materials
(Elsevier Sci Ltd, 2008)
The effect of sea water on the bearing strength behavior of the woven glass fibre composite has been investigated experimentally. The ratio of the edge distance to the pin diameter (E/D), and the ratio of the specimen width ...
Numerical and experimental stress analysis of a polymeric composite hip joint prosthesis
(John Wiley & Sons Inc, 1996)
A comparative stress analysis of a polymeric composite hip joint replacement was performed. A prototype short carbon-fiber reinforced PEEK (CF/PEEK) prosthesis was manufactured by injection molding. Finite element (FE) ...
A numerical study of laminar heat convection in ducts of irregular cross-sections
(Pergamon-Elsevier Science Ltd, 1997)
Forced convective heat transfer during hydrodynamically fully developed laminar fluid flow inside ducts of irregular cross section is analyzed utilizing numerical methods. The elliptic grid generation technique is used to ...