Ara
Toplam kayıt 71, listelenen: 1-10
Improving performance of switched reluctance motor by fuzzy logic controller
(John Wiley & Sons Ltd, 1999)
This paper presents torque ripple minimization of a switched reluctance motor (SRM) by using a fuzzy controller, The nonlinear model of the SRM and the mathematical model of the converter circuit are driven. The motor used ...
Analytical solution for continuous-time Kalman tracking filters with colored measurement noise in frequency domain
(Ieee-Inst Electrical Electronics Engineers Inc, 1994)
New expressions are given for analytical solutions to the steady-state Kalman gains of the two-state exponentially correlated velocity (ECV) and the three-state exponentially correlated acceleration (ECA) tracking filters ...
Analysis of orthotropic plate structures by the direct-dynamic stiffness method
(Pergamon-Elsevier Science Ltd, 1995)
…
A numerical study of laminar heat convection in ducts of irregular cross-sections
(Pergamon-Elsevier Science Ltd, 1997)
Forced convective heat transfer during hydrodynamically fully developed laminar fluid flow inside ducts of irregular cross section is analyzed utilizing numerical methods. The elliptic grid generation technique is used to ...
Ultrasonic array imaging based on spatial interpolation
(I E E E, 1996)
…
A fuzzy colour quantizer for renderers
(Elsevier Science Bv, 1998)
This paper presents a new colour quantization method for ray tracing. Normally, quantization is carried out by generating statistics about the colours present in the original image. Then a colour look-up table is created ...
Adaptive multi-element synthetic aperture imaging with motion and phase aberration correction
(Ieee-Inst Electrical Electronics Engineers Inc, 1998)
Multi-element synthetic aperture techniques employing subaperture processing over successive firing steps can produce good image quality with simple front-end hardware but are susceptible to motion and phase aberration ...
Failure analysis of two-dimensional carbon-epoxy composite plate pinned joint
(Taylor & Francis Inc, 1999)
The aim of this study is to investigate failure strength and failure mode of a mechanically fastened carbon-epoxy composite plate of arbitrary orientation. The failure load and the failure mode are analyzed numerically and ...
Numerical and experimental stress analysis of a polymeric composite hip joint prosthesis
(John Wiley & Sons Inc, 1996)
A comparative stress analysis of a polymeric composite hip joint replacement was performed. A prototype short carbon-fiber reinforced PEEK (CF/PEEK) prosthesis was manufactured by injection molding. Finite element (FE) ...
Application of the dynamic stiffness technique to the in-plane vibrations of plate structures
(Pergamon-Elsevier Science Ltd, 1996)
In this study the dynamic stiffness technique, which yields ''exact'' results for a certain class of plate structure, is extended to include in-plane vibrations. Using the equations of motion and edge tractions the stiffness ...