Ara
Toplam kayıt 102, listelenen: 91-100
Modelling of yield length in the mould of commercial plastics using artificial neural networks
(Elsevier Sci Ltd, 2007)
According to the yield length of a plastic, whether a mould is filled fully or not can be estimated. In this study, a new formula based on various injection parameters was developed to determine the yield length in plastic ...
Prospects for future projections of the basic energy sources in Turkey
(Taylor & Francis Inc, 2007)
The main goal of this study is to develop the energy sources estimation equations in order to estimate the future projections and make correct investments in Turkey using artificial neural network (ANN) approach. It is ...
Comparative study of mathematical and experimental analysis of spark ignition engine performance used ethanol-gasoline blend fuel
(Pergamon-Elsevier Science Ltd, 2007)
This study consists of two cases: (i) The experimental analysis: Ethanol obtained from biomass can be used as a fuel in spark ignition engines. As renewable energy source ethanol, due to the high octane number, low emissions ...
Calculation for the thermodynamic properties of an alternative refrigerant (R508b) using artificial neural network
(Pergamon-Elsevier Science Ltd, 2007)
This study proposes a alternative approach based on artificial neural networks (ANNs) to determine the thermodynamic properties - specific volume, enthalpy and entropy - of an alternative refrigerant (R508b) for both ...
Exergy analysis of an ejector-absorption heat transformer using artificial neural network approach
(Pergamon-Elsevier Science Ltd, 2007)
This paper proposes artificial neural networks (ANNs) technique as a new approach to determine the exergy losses of an ejector-absorption heat transformer (EAHT). Thermodynamic analysis of the EAHT is too complex due to ...
Artificial neural network application to the friction-stir welding of aluminum plates
(Elsevier Sci Ltd, 2007)
An artificial neural network (ANN) model was developed for the analysis and simulation of the correlation between the friction stir welding (FSW) parameters of aluminium (Al) plates and mechanical properties. The input ...
Design optimization of cutting parameters when turning hardened AISI 4140 steel (63 HRC) with Al2O3+TiCN mixed ceramic tool
(Elsevier Sci Ltd, 2007)
Due to their high hardness and wear resistance, Al2O3-based ceramics are one of the most suitable cutting tool materials for machining hardened steels. However, their high degree of brittleness usually leads to inconsistent ...
Designing of a powder compressing device with vibration and investigation of compressibility of MgO powders with this device
(Elsevier Sci Ltd, 2007)
One of metal matrix composite (MMC) production methods is infiltration of liquid metal into preformed reinforcement. In this method, MMCs are produced by infiltration of liquid metal into preformed reinforcement using one ...
Determination of residual stresses based on heat treatment conditions and densities on a hybrid (FLN2-4405) powder metallurgy steel using artificial neural network
(Elsevier Sci Ltd, 2007)
This paper presents a new approach based on artificial neural networks (ANNs) to determine the residual stresses in PM steel based nickel (FLN2-4405). This study consists of two cases: (i) The experimental analysis: The ...
Experimental modelling and simulation with adaptive control of power plant
(Pergamon-Elsevier Science Ltd, 2007)
This study presents a typical industrial plant whose performance is severely affected by disturbances, particularly by changes in the operating point. This is typically the case for power plants, which can be treated as ...