An investigation of surface quality of turning in al matrix mgo reinforced composite material

Basit Öğe Kaydı
dc.contributor.authorPul, Muharrem
dc.contributor.authorÇalın, Recep
dc.contributor.authorCitak, Ramazan
dc.contributor.authorSeker, Ulvi
dc.date.accessioned2020-06-25T17:51:57Z
dc.date.available2020-06-25T17:51:57Z
dc.date.issued2011
dc.departmentKırıkkale Üniversitesi
dc.description.abstractIn this study; Al/MgO composites having 5 %, 10 %, 15 % volume fraction of reinforcement are produced by vacuum infiltration method and microstructure of composites are determined. Produced materials of metal matrix composite (MMC) machined with uncoated cemented carbide (WC), cubic boron nitrite (CBN) and coated cubic boron nitrite (CBN-C) cutting tools. The average surface roughness values (Ra) are determined by measuring surface roughnesses of composite samples. Ra values showed tendency to decrease by increasing cutting rate but it has proportionality with raising feed rates. The maximum roughness value is obtained at the cutting speed of 150 rev/min. It was observed that the most raugh sample is 15 % MgO reinforced sample. In terms of surface roughness 15 % MgO reinforced material is determined as the worst machinable sample. The best surface quality is obtained with WC cutting tool while machining 5 % and 10 % MgO reinforced samples and the best results are obtained 15 % MgO reinforced samples with CBN-C tools at high feed rates.en_US
dc.identifier.citationclosedAccessen_US
dc.identifier.endpage88en_US
dc.identifier.issn1300-1884
dc.identifier.issue1en_US
dc.identifier.startpage81en_US
dc.identifier.urihttps://hdl.handle.net/20.500.12587/5038
dc.identifier.volume26en_US
dc.identifier.wosWOS:000289174900009
dc.identifier.wosqualityQ4
dc.indekslendigikaynakWeb of Science
dc.language.isotr
dc.publisherGazi Univ, Fac Engineering Architectureen_US
dc.relation.ispartofJournal Of The Faculty Of Engineering And Architecture Of Gazi University
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectComposite materialsen_US
dc.subjectInfiltrationen_US
dc.subjectTurningen_US
dc.subjectSurface roughnessen_US
dc.titleAn investigation of surface quality of turning in al matrix mgo reinforced composite materialen_US
dc.typeArticle

Dosyalar

Orijinal paket
Listeleniyor 1 - 1 / 1
[ X ]
İsim:
An investigation of surface quality of turning in al matrix mgo reinforced composite material.pdf
Boyut:
946.8 KB
Biçim:
Adobe Portable Document Format
Açıklama:
Tam Metin/Full Text
İndir

Koleksiyon

WOS İndeksli Yayınlar Koleksiyonu
Makale Koleksiyonu