Modelling requirements for computer simulation of metal machining

Basit Öğe Kaydı
dc.contributor.authorDirikolu M.H.
dc.contributor.authorChilds T.H.C.
dc.date.accessioned2020-06-25T15:13:12Z
dc.date.available2020-06-25T15:13:12Z
dc.date.issued2000
dc.departmentKırıkkale Üniversitesi
dc.description.abstractMachining modelling efforts are summarised and some important shortcomings of these are presented. The reasons for these shortcomings have been investigated. The investigations are based on machining simulation research and accompanying experimental studies. The reasons are found to be mainly in the approaches taken towards modelling the mesh and boundary conditions, the flow stress of the workpiece material and the frictional properties at the interface between the chip and the cutting tool. The handlings of the extremely high temperature increases and the mechanism taking place during separation of the chip from the workpiece by the tool are also among the significant reasons. The aim of this paper is to present some solutions towards modelling these aspects of machining.en_US
dc.identifier.endpage93en_US
dc.identifier.issn13000160
dc.identifier.issue2en_US
dc.identifier.scopus2-s2.0-0033868517
dc.identifier.scopusqualityN/A
dc.identifier.startpage81en_US
dc.identifier.urihttps://hdl.handle.net/20.500.12587/1653
dc.identifier.volume24en_US
dc.indekslendigikaynakScopus
dc.language.isoen
dc.relation.ispartofTurkish Journal of Engineering and Environmental Sciences
dc.relation.publicationcategoryMakale - Ulusal Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectChip separationen_US
dc.subjectFlow characteristicsen_US
dc.subjectFriction characteristicsen_US
dc.subjectMachiningen_US
dc.subjectSimulationen_US
dc.titleModelling requirements for computer simulation of metal machiningen_US
dc.typeArticle

Dosyalar

Koleksiyon

Scopus İndeksli Yayınlar Koleksiyonu