Investigation of the Effects of Cutting Fluid Application with Minimum Quantity Lubrication (MQL) Method on the Machinability of Pure Titanium

Basit Öğe Kaydı
dc.contributor.authorKartal, Yunus
dc.contributor.authorEr, Ali Osman
dc.date.accessioned2025-01-21T16:14:07Z
dc.date.available2025-01-21T16:14:07Z
dc.date.issued2024
dc.departmentKırıkkale Üniversitesi
dc.description.abstractMachining is one of the widely used methods in today's technology and there are many parameters that affect the machinability of the produced product. In the machining process, the machinability of the product depends on parameters such as feed rate, depth of cut, cutting speed and cutting fluid. The use of cutting fluid during the process has advantages such as improving surface quality, but also disadvantages such as increased cost and environmental damage. Due to these disadvantages of cutting fluid in manufacturing processes, alternative methods have been developed. The method called minimum quantity lubrication (MQL) not only reduces cost but also improves machinability. In this study, the machinability of titanium turning was evaluated with main cutting force, surface roughness and temperature measured in the primary cutting zone data. MQL method was used in the study and Taguchi L9 model was applied. The results were compared between dry cutting and MQL atmospheres. The reliability of the data and the degree of influence of the parameters were analyzed by ANOVA. In this study, the shear force data obtained in the dry shear atmosphere were higher than the data obtained in the MQL method. In addition, the surface roughness values obtained in dry cutting atmosphere were also relatively high. The optimum cutting speed, feed rate and depth of cut values for the process were determined as 60 m/min, 0.05 mm/rev and 0.5 mm, respectively.
dc.identifier.doi10.16984/saufenbilder.1331381
dc.identifier.endpage9
dc.identifier.issn1301-4048
dc.identifier.issn2147-835X
dc.identifier.issue1
dc.identifier.startpage1
dc.identifier.trdizinid1226894
dc.identifier.urihttps://doi.org/10.16984/saufenbilder.1331381
dc.identifier.urihttps://search.trdizin.gov.tr/tr/yayin/detay/1226894
dc.identifier.urihttps://hdl.handle.net/20.500.12587/22078
dc.identifier.volume28
dc.indekslendigikaynakTR-Dizin
dc.language.isoen
dc.relation.ispartofSakarya Üniversitesi Fen Bilimleri Enstitüsü Dergisi
dc.relation.publicationcategoryMakale - Ulusal Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/openAccess
dc.snmzKA_20241229
dc.subjectMühendislik
dc.subjectMakine
dc.subjectYeşil
dc.subjectSürdürülebilir Bilim ve Teknoloji
dc.subjectMalzeme Bilimleri
dc.subjectÖzellik ve Test
dc.titleInvestigation of the Effects of Cutting Fluid Application with Minimum Quantity Lubrication (MQL) Method on the Machinability of Pure Titanium
dc.typeArticle

Dosyalar

Koleksiyon

TR-Dizin İndeksli Yayınlar Koleksiyonu