Rapid fabrication of microfluidic PDMS devices from reusable PDMS molds using laser ablation

Yükleniyor...
Küçük Resim

Tarih

2016

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

Iop Publishing Ltd

Erişim Hakkı

info:eu-repo/semantics/openAccess

Özet

The conventional fabrication methods for microfluidic devices require cleanroom processes that are costly and time-consuming We present a novel, facile, and low-cost method for rapid fabrication of polydimethylsiloxane (PDMS) molds and devices. The method consists of three main fabrication steps: female mold (FM), male mold (MM), and chip fabrication. We use a CO, laser cutter to pattern a thin, spin -coated PDMS layer for FM fabrication. We then obtain reusable PDMS MM from the FM using PDMS/PDMS casting. Finally, a second casting step is used to replicate PDMS devices from the MM. Demolding of one PDMS layer from another is carried out without any potentially hazardous chemical surface treatment. We have successfully demonstrated that this novel method allows fabrication of microfluidic molds and devices with precise dimensions (thickness, width, length) using a single material, PDMS, which is very common across microfluidic laboratories. The whole process, from idea to device testing, can be completed in 1.5 h in a standard laboratory.

Açıklama

GULER, MUSTAFA TAHSIN/0000-0002-0478-3183; Elbuken, Caglar/0000-0001-8359-6871

Anahtar Kelimeler

microfabrication, microfluidics, rapid prototyping, laser ablation, microdroplet generation

Kaynak

Journal Of Micromechanics And Microengineering

WoS Q Değeri

Q2

Scopus Q Değeri

Q2

Cilt

26

Sayı

3

Künye

Ziya Isiksacan et al 2016. Rapid fabrication of microfluidic PDMS devices from reusable PDMS molds using laser ablation. Journal of Micromechanics and Microengineering 26(3),035008.