Investigation of machinability by electrical discharge machining method of ZA27/MWCNT composites produced by powder metallurgy

[ X ]

Tarih

2024

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

Yildiz Technical University

Erişim Hakkı

info:eu-repo/semantics/openAccess

Özet

In recent years, nano-doped metal matrix composites have started to take place among the developed composites. In this study, powder metal undoped ZA27 alloy and 0.5% wt% multi-walled carbon nanotube (MWCNT) doped nano-composite machinability in EDM (electrical discharge machining) were researched. Microstructures of ZA27 nano-doped composites were examined under a scanning electron microscope (SEM), and their hardness measurements were made. Obtained test results were compared with that of ZA27 samples without nanodoped. In the SEM analysis, the production method applied was generally successful, and the porous regions encountered in some parts of the composite structure were due to the difficulty in homogeneously dispersing the MWCNT reinforcement material. The metal’s material removal rate (MRR) increased with the addition of MWCNT powders that raised conductivity and decreased tool wear rate (TWR) compared to the pure ZA27 material. © 2024 Yildiz Technical University. All rights reserved.

Açıklama

Anahtar Kelimeler

EDM; Machinability; Metal Matrix Nano Composite; MWCNT; ZA27

Kaynak

Sigma Journal of Engineering and Natural Sciences

WoS Q Değeri

Scopus Q Değeri

Q3

Cilt

42

Sayı

6

Künye