Effects of Some Mineral Wools and Adhesives on Burning Characteristics of Particleboard
Yükleniyor...
Tarih
2015
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
North Carolina State Univ Dept Wood & Paper Sci
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
In this study, effects of adhesive and additive's type and ratio on burning characteristics of particleboard (PB) added glass wool (GW) and rock wool (RW) were researched. PB's furnish was derived from 50% Crimean pine, 30% Eastern Black Sea oak, 15% quaking aspen, and 5% residues of wood machining, and moisture content of furnish was 1.5 to 3%. Seventy PBs with 0.64 g/cm(3) density, urea formaldehyde (UF)/melamine formaldehyde (MF) fixed amount, 14 mm thickness, 45x45 cm(2) dimensions and 10%, 15%, 20% SW/GW additives were produced. The 150 degrees C pressing temperature with 25 kg/cm(2) compression pressure was constant. Burning tests for determination of ignition time, flaming combustion temperature, flaming combustion duration, smoldering combustion duration, and mass loss during burning were made according to DIN4102 standards. According to the results of the tests, adhesive type did not affect ignition time and mass loss. While flaming combustion temperature of PB with UF was 19% higher, flaming combustion duration and smoldering combustion duration was 32% and 29% lower than those of PB with MF, respectively. While ignition time of PB with GW was 50% higher than that of PB with RW, changes in burning properties were similar for both PBs. An increase in the content of GW and RW affected burning properties of PB positively and an increase of ignition time up to 196% were obtained.
Açıklama
Anahtar Kelimeler
Particleboard, Rock wool, Glass wool, Wood composite, Fire resistance
Kaynak
Bioresources
WoS Q Değeri
Q1
Scopus Q Değeri
Q3
Cilt
10
Sayı
2
Künye
Ülker, O., and Burdurlu, E. (2015). "Effects of some mineral wools and adhesives on burning characteristics of particleboard," BioRes. 10(2), 3775-3789.