Tool wear evaluation by vibration analysis during end milling of AISI D3 cold work tool steel with 35 HRC hardness

Basit Öğe Kaydı
dc.contributor.authorOrhan, Sadettin
dc.contributor.authorEr, Ali Osman
dc.contributor.authorCamuscu, Necip
dc.contributor.authorAslan, Ersan
dc.date.accessioned2020-06-25T17:43:57Z
dc.date.available2020-06-25T17:43:57Z
dc.date.issued2007
dc.descriptionOrhan, Sadettin/0000-0002-9751-6665
dc.description.abstractIn this study, the relationship between vibration and tool wear was investigated during end milling. For this purpose, a series of experiment were conducted in a vertical milling machine. An indexable CBN insert and AISI D3 cold work tool steel hardened to 35 HRC were used as material twin in the experiments. The vibration was measured only in the machining direction, which has more dominant signals than in the other two directions. The measurements were taken by using an acceleration sensor assembled on a machinery analyzer. Tool wear was measured by a toolmaker's microscope. It was observed that there was an increase in vibration amplitude with increasing tool wears. This situation was evident especially by monitoring vibration of displacement type. It was also observed that the first three multiplies of tooth passing frequency (1 x, 2 x, 3 x) gave the best information about the tool wear. Results showed that there was no considerable increase in the vibration amplitude until a flank wear value of 160 mu m was reached, above which the vibration amplitude increased significantly. (C) 2006 Elsevier Ltd. All rights reserved.en_US
dc.identifier.citationclosedAccessen_US
dc.identifier.doi10.1016/j.ndteint.2006.09.006
dc.identifier.endpage126en_US
dc.identifier.issn0963-8695
dc.identifier.issue2en_US
dc.identifier.scopus2-s2.0-33845220150
dc.identifier.scopusqualityQ1
dc.identifier.startpage121en_US
dc.identifier.urihttps://doi.org10.1016/j.ndteint.2006.09.006
dc.identifier.urihttps://hdl.handle.net/20.500.12587/3959
dc.identifier.volume40en_US
dc.identifier.wosWOS:000243831900003
dc.identifier.wosqualityQ1
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoen
dc.publisherElsevier Sci Ltden_US
dc.relation.ispartofNdt & E International
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjecttool wearen_US
dc.subjectvibration monitoringen_US
dc.subjectend millingen_US
dc.subjectcold work tool steelen_US
dc.subjecthardnessen_US
dc.titleTool wear evaluation by vibration analysis during end milling of AISI D3 cold work tool steel with 35 HRC hardnessen_US
dc.typeArticle

Dosyalar

Orijinal paket
Listeleniyor 1 - 1 / 1
[ X ]
İsim:
1-s2.0-S0963869506001034-main.pdf
Boyut:
400.31 KB
Biçim:
Adobe Portable Document Format
Açıklama:
Tam metin/Full text
İndir

Koleksiyon

WOS İndeksli Yayınlar Koleksiyonu
Makale Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu